Windows

ARP Commands

Displays and modifies the IP-to-Physical address translation tables used by
address resolution protocol (ARP).

ARP -s inet_addr eth_addr [if_addr]
ARP -d inet_addr [if_addr]
ARP -a [inet_addr] [-N if_addr] [-v]

-aDisplays current ARP entries by interrogating the current protocol data. If inet_addr is specified, the IP and Physical addresses for only the specified computer are displayed. If more than one network interface uses ARP, entries for each ARP table are displayed.
-g Same as -a.
-vDisplays current ARP entries in verbose mode. All invalid entries and entries on the loop-back interface will be shown.
inet_addrSpecifies an internet address.
-N if_addr Displays the ARP entries for the network interface specified by if_addr.
-d Deletes the host specified by inet_addr. inet_addr may be wildcarded with * to delete all hosts.
-s Adds the host and associates the Internet address inet_addr with the Physical address eth_addr. The Physical address is given as 6 hexadecimal bytes separated by hyphens. The entry is permanent.
eth_addrSpecifies a physical address.
if_addr If present, this specifies the Internet address of the interface whose address translation table should be modified. If not present, the first applicable interface will be used.

Example:

arp -s 157.55.85.212 00-aa-00-62-c6-09 …. Adds a static entry.
arp -a …. Displays the arp table.

Leave a Reply

Your email address will not be published. Required fields are marked *